How to connect the power vibration motor

    Vibration motor vibrating screen manufacturers of the cable due to bear , so should be used in heavy-duty four -core cable , cable outlet is not allowed near sharp bends , to have a 8-9 times

greater than the outer diameter of the cable bend radius , and then the cable is not fixed to the stationary moving coal crushing plant the machine or the frame . Its large distance

Approximately 0.6 m to 0.9 m . In the fixed cable clamp Department should pad with soft insulating material to prevent friction damage to the cable. Four core cable ground wire

, one end of the junction box is connected to the grounding screw , the other end must be grounded . Small models vibration motor, chassis no wiring

Boxes, using heavy three -core cable directly from the inside of the motor wiring. Near the foot of the motor is equipped with grounding screw , use must be grounded.
Note: The vibration motor cable outlet for the wearing parts, often due to vibration friction damage, leading to motor phase operation, damage to the motor . Users should always

check the cable position should be replaced if worn the same type cable.