Shaker operation and maintenance is essential

Shaker operation and maintenance is essential, improper operation, is likely to affect the life of the shaker, reasonable maintenance can extend the life of vibrating screen,

vibrating screen This section focuses on the operation and maintenance of explaining to do next.
(1) in the car, the operator simultaneously on both sides by shaker should check the oil level, oil temperature rises too high will cause the exciter or the operating

difficulties, the oil surface is too low will result in premature failure of the bearing.
(2) Check the tightness of all bolts and 8h after the initial work, re-tighten again.
(3) Check the tension of V-belt, to prevent slipping at the start or at work, and to ensure the positive V pulley.
(4) Ensure that all moving parts and the minimum clearance between fixtures.
(5) sieve shall start no load conditions, to be running smoothly after a sieve in order to begin feeding, stop should stop feeding until the screen surface material drained

after shutdown.
(6) should be as close as possible to the chute to the discharge end, and as far as possible uniformly distributed along the full width of the sieve feed, and its direction is   Semi-mobile crushing plant

consistent with the direction of the screen surface material, resulting in the best screening effect. Feeding point to the screen surface is not greater than the maximum gap

500mm, ensuring minimal material impact on the screen surface.
(7) along the material flow direction rotary shaker, an increase in the speed of materials, increase production capacity, but reduced screening efficiency; when the exciter

foresee flow direction is reversed, reducing the material running speed and reduce production capacity, improve efficiency of efficiency  crushing plant